How To Make A Vanity Mirror Frame

I worked my way from the bottom up. Apply your liquid nails or glue to the back of the board but make sure to leave an inch or so at the top of the board so you wont see the glue reflected in the mirror.

Diy Framed Bathroom Mirrors Living With Lady

Also add the heavy duty picture hanging kit.

How to make a vanity mirror frame. Then he mitered all the corners of all 4 pieces of wood at a 45 degree angle. To attach the frame you first need to pre mark the holes for where you are going to drill the holes for the nailing the top board to the frame. These two pieces of wood are what brings the mirror frame up to the height of the lights.

Cover until you are happy with the look. I used tape to hold it in place while it dried. Make it a floating mirror by insetting it into the rest of the tile or wall add a shelf or a frame that can double as a shelf to enhance practicality suspend it from the wall to create depth and intrigue.

Mark these measurements on your MDF boards and use a miter saw to make your cuts. The first step is to measure your vanity mirror length and width. Before pre drilling the holes I glued the frame to the top board and put wieghts on it to hold it together.

Heres one of the corners dont be afraid if they dont match up perfectly. Screw the 4 mirror clips onto the frame. To make the mirror frame Kevin first used his table saw to cut a 14 by 14 groove in the corner of the 1-inch square trim piece.

Next we screwed the other two 24 pieces onto the frame. Continue this until fully covered. The mirror is just a hair below 24x 36 so you can make you cuts 116 short or sand it down once the cut is made.

Hang use the picture hanging kit and a screw into a stud in the wall or with an appropriately weighted drywall anchor system. Before we glued anything onto the mirror I had Hubby hold the boards in place to make sure that I liked the way they looked. You can recreate this using whatever color spray paint you want and.

Nothing that a bit of caulk cant fix. The first step is to hold the long frame pieces up to the mirror then draw an outline on the wood where the clips will align on the frame. Be careful not to over-screw which can.

The frame board is 1 so i measure in from the edge 12 inch and drew a line in from the edge. Once your light bulbs are installed your DIY vanity mirror with lights is finally ready to go. You can make a wooden frame for your mirror which would actually also have a practical use.

This way your new vanity mirror will look neat and stylish and will have lights. This DIY vanity mirror isnt wall-mounted but its a great makeup mirror for your vanity table and the way the blogger customized it is definitely unique. Using your miter saw cut your wood at a 45-degree angle so the outside portion of your wood piece will be the full length of the mirror see pic above.

Use a tape measure to measure the width and height of your mirror. You can also glue the mirror in place. Cutting Around Mirror Clips Now youll want to chisel out a gap in the frame where you traced your clips.

Make cuts for all four sides. This would create the little notches where the trim would rest on the edge of the mirror. Drill holes in it for the lights and carefully hide all the wires behind the frame.

I marked holes three inches apart. 10Rockstar Spiked Mirror. Stay about 1 foot distance from the mirror and use short bursts in the same direction.

Add the mirror to the back of the frame with the mirror clips. For the final step youll screw your light bulbs to the front of the vanity mirror frame into the light sockets you just installed. Definitely make the outline bigger because it gives you some play so the frame actually aligns.

Take your mirror to a well ventilated space garage or outside and carefully spray the exposed frame. Once the glued dryed i pre-drilled holes for the.

How To Frame A Mirror Hgtv